Struct h2::ReleaseCapacity

pub struct ReleaseCapacity { /* fields omitted */ }

A handle to release window capacity to a remote stream.

This type allows the caller to manage inbound data flow control. The caller is expected to call release_capacity after dropping data frames.

Overview

Each stream has a window size. This window size is the maximum amount of inbound data that can be in-flight. In-flight data is defined as data that has been received, but not yet released.

When a stream is created, the window size is set to the connection's initial window size value. When a data frame is received, the window size is then decremented by size of the data frame before the data is provided to the caller. As the caller finishes using the data, release_capacity must be called. This will then increment the window size again, allowing the peer to send more data.

There is also a connection level window as well as the stream level window. Received data counts against the connection level window as well and calls to release_capacity will also increment the connection level window.

Sending WINDOW_UPDATE frames

WINDOW_UPDATE frames will not be sent out for every call to release_capacity, as this would end up slowing down the protocol. Instead, h2 waits until the window size is increased to a certain threshold and then sends out a single WINDOW_UPDATE frame representing all the calls to release_capacity since the last WINDOW_UPDATE frame.

This essentially batches window updating.

Scenarios

Following is a basic scenario with an HTTP/2.0 connection containing a single active stream.

• A new stream is activated. The receive window is initialized to 1024 (the value of the initial window size for this connection).
• A DATA frame is received containing a payload of 400 bytes.
• The receive window size is reduced to 424 bytes.
• release_capacity is called with 200.
• The receive window size is now 624 bytes. The peer may send no more than this.
• A DATA frame is received with a payload of 624 bytes.
• The window size is now 0 bytes. The peer may not send any more data.
• release_capacity is called with 1024.
• The receive window size is now 1024 bytes. The peer may now send more data.

Methods

impl ReleaseCapacity

pub fn release_capacity(&mut self, sz: usize) -> Result<(), Error>

Release window capacity back to remote stream.

This releases capacity back to the stream level and the connection level windows. Both window sizes will be increased by sz.

See struct level documentation for more details.

Panics

This function panics if increasing the receive window size by sz would result in a window size greater than the target window size set by set_target_window_size. In other words, the caller cannot release more capacity than data has been received. If 1024 bytes of data have been received, at most 1024 bytes can be released.

Trait Implementations

impl Debug for ReleaseCapacity

fn fmt(&self, f: &mut Formatter) -> Result

Formats the value using the given formatter.

impl Clone for ReleaseCapacity

fn clone(&self) -> Self

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.